GEO5 Catalog

GEO5 Slope Stability is used to perform slope stability analysis (embankments, earth cuts, anchored retaining structures, MSE walls, etc.). The sli...

The Slope Stability – Water Flow add-on allows the determination of the pore pressures in the slope by using the steady state or transient groundwa...

This program is used for the design of gabion walls. It allows analysis of any structure shapes including overhangs requiring anchoring.

This program is used for the design of reinforced masonry block walls.

This program is used for the design of gravity retaining walls. It offers a variety of wall shapes.  

This program is used for the design of cantilever retaining walls. It offers a variety of wall shapes.

This program is used for the design of retaining walls made of prefabricated blocks.

This program is used for the analysis and design of mechanically stabilized earth (MSE) walls and segmental retaining walls reinforced by geogrids ...

This program is used for designing advanced retaining walls using the Redi-Rock wall system (USA). The program is identical to the RRWall+ program ...

This program is used for the analysis and design of bridge abutments including wing walls. It allows checking the abutment for overturning, transla...

The Finite Element Method (FEM) program is used for modeling and analysis of a wide range of geotechnical problems, including terrain settlement, s...

The FEM Water Flow add-on requires FEM (Proper) as the underlying program. The FEM Water Flow is used for the analysis of steady-state or transient...

The FEM Consolidation add-on requires FEM (Proper) as the underlying program. The FEM Consolidation is used for the analysis of time-dependent sett...

The FEM Tunnel add-on requires FEM (Proper) as the underlying program. The FEM Tunnel is used for the analysis and design of tunnels. It includes s...

The FEM Earthquaqe add-on requires FEM (Proper) as the underlying program. The FEM Earthquake is used for the dynamic analysis of geotechnical stru...

Program Laboratory provides effective processing and analysis of laboratory tests of soils and rocks. The program is not only intended for laborato...

The GEO5 Stratigraphy program is designed to process results from site investigation (boreholes, wells, CPTs, DPTs, SPTs, DMTs ...), generate and e...

The Stratigraphy Logs add-on requires Stratigrhapy (Proper) as the underlying program. The program is used for subsurface exploration reporting fro...

The Stratigraphy Cross Sections add-on requires Stratigrhapy (Proper) as the underlying program. The program is used for the creation of subsurface...

The Stratigraphy Earthworks add-on requires Stratigrhapy (Proper) as the underlying program. The program is used for 3D modeling of foundation pits...

The program allows fast processing of point clouds (up to 100 million points) and export of resulting points into the Stratigraphy program or exter...

This program computes earth pressures acting upon an arbitrarily shaped structure; active pressure, passive pressure, and pressure at rest.

This program is used for a quick design of non-anchored walls and to make a preliminary design of anchored retaining walls (Sheet pile, Soldier pil...

This program is used for the advanced analysis and design of excavation and embedded retaining walls using the method of elasto-plastic non-linear ...